REASERCH ON DETERMINATION FOR THE LIMITED COMPRESSIVE STRENGTH AND BENDING MOMENT OF THE STEEL COLUMN BASE USING EFFECTIVE AREA PANDEMIC

Main Article Content

Hao Phuoc Bui

Abstract

In the design of steel column base, parameters of limited compressive strength NRd and limited bending moment MRd are the control conditions that need to be paid due attention, otherwise it will damage the concrete foundation block at the foot of the column. The objective of the article is to use the effective area method in Eurocode 3 standard to determine NRd and MRd of the steel column base, then perform numerical
calculations to check the calculation results. The results show that the NRd and MRd of the steel column base tends to increase when increasing the thickness of the base plate and the grade of the concrete foundation block. Then, corresponding to each thickness of the base plate (from t=18 mm to t=36 mm) and each concrete grade (from C16/20 to C50/60) will give corresponding results for each NRd and MRd. However, it is important to note that the compressive capacity and bending moment of the column base will be limited, can not increase forever, for example, can not overcome the compressive strength Npl;Rd = 1596 kN and the limit bending  strength Mpl;Rd=131.3 kN.m of the concrete foundation block at the base of the column. The article recommends using the results of this study to choose the thickness of the base plate and the grade of the
concrete foundation block in the most effective, accurate and economical way.

Downloads

Download data is not yet available.

Article Details

How to Cite
1.
Bui H. REASERCH ON DETERMINATION FOR THE LIMITED COMPRESSIVE STRENGTH AND BENDING MOMENT OF THE STEEL COLUMN BASE USING EFFECTIVE AREA PANDEMIC. journal [Internet]. 28Mar.2022 [cited 29Mar.2024];12(46):71-. Available from: https://journal.tvu.edu.vn/index.php/journal/article/view/863
Section
Articles

References

[1] Bộ Khoa học và Công nghệ. TCVN 5575:2012. Kết
cấu thép – tiêu chuẩn thiết kế. Hà Nội: Bộ Khoa học
và Công nghệ; 2012. [Ministry of Science and Technology of Vietnam. TCVN 5575:2012. Steel structures
– design standard. Hanoi: Ministry of Science and
Technology of Vietnam; 2012].
[2] Rosca VE, Teleman EC, Axinte E, Baetu G. Design of
steel column base connections for large eccentricities.
Gheorghe Asachi Technical University of Iasi Faculty
of Civil Engineering and Building Services; 2013.
[3] Wald F, Jaspart JP, Brown D. Base plate in bending
and anchor bolts in tension – third. Journal of Constructional Steel Research. 2000.
[4] Moore DB, Walf F. Design of structural connections
to Eurocode 3 frequently asked questions. Prague,
Czech: Publishing House of Czech Technical University; 2003.
[5] The European Union. EN 1993-1-8, Eurocode 3:
Design of steel structures–Part 1-8: Design of joints;
2005.
[6] The European Union. EN 1993-1-1. Eurocode 3:
Design of steel structures–Part 1-1: General rules
and rules for buildings. The European Union; 2005.
[7] Kuhlmann U, Wald F, Hofmann J. Design of SteeltoConcrete Joints Design Manual II. In: 7th European Conference on Steel and Composite Structures.
Naples, Italy. 2014.